P a g e 6 | 49
DEVICE IS GETTING WARM AFTER PROLONGED USE
When using your device for prolonged periods the device may become warm. In most
cases this condition is normal and therefore should not be interpreted as a problem with
the device.
HEED SERVICE MARKING
Except as explained in the user manual, do not repair any product yourself. Service needed
on components inside the device should be done by an authorized service outlet or
provider.
Phicomm (Shanghai) Co., Ltd. is entitled to use new or reconditioned replacements parts
or boards for repairs under warranty, provided they have the same functionality as the parts
to be replaced.
DAMAGE REQUIRING SERVICE
Unplug the device from the electrical outlet and refer servicing to an authorized service
center or provider under the following conditions:
•
Liquid has been spilled or an object has fallen onto the product.
•
The product has to been exposed to rain or water.
•
There are noticeable signs of overheating.
•
The product does not operate normally when you follow the operating instructions.
AVOID HOT AREAS
The product should be placed away from heat sources such as radiators, heat registers,
stoves, or other products (including amplifiers) that products heat.
AVOID WET AREAS
Never use the product in a wet location.
AVOID USING YOUR DEVICE AFTER A DRAMATIC CHANGE IN TEMPERATURE
When you move your device between environments with very different temperature and/or
humidity ranges, condensation may form on or within the device. To avoid damaging the
device, allow sufficient time for the moisture to evaporate before using the device.
NOTICE: When taking the device from low-temperature conditions into a warmer
environment or from high-temperature conditions into a cooler environment, allow the
device to acclimate to room temperature before turning on power.
AVOID PUSHING OBJECTS INTO THE DEVICE
Never push objects of any kind into cabinet slots or other openings in the product. Slots
and openings are provided for ventilation. These openings must not be blocked or covered.
P a g e 7 | 49
MOUNTING ACCESSORIES
Do not use the product on an unstable table, cart, tripod or bracket. Any mounting of the
product should follow the manufacturer’s instructions and should use a mounting
accessory recommended by the manufacturer.
AVOID UNSTABLE MOUNTING
Do not place the product with an unstable base.
USE PRODUCT WITH APPROVED EQUIPMENT
This product should be used only with personal computers and options identified as
suitable for use with your equipment.
CLEANING
Unplug the product from the wall outlet before cleaning. Do not use liquid cleaners or
aerosol cleaners. Use a damp cloth for cleaning, but NEVER use water to clean the device.
The device has been provided with special treatments featuring that it could dispose dirt
and sweat on its surface. The device itself does not have a stain-resistant function. In case
of smudginess and dyeing, please wipe it with clean damp sponge immediately. Please
keep the device dry when necessary.
PACEMAKER
The device may cause disturbance to pacemakers. Please keep the device a
proper distance of least 5 centimeters away from pacemakers.
If you need detailed information about other active implantable medical
devices, please consult your doctor to ensure the magnetic interference of
such active implantable medical devices.
CAUTION
Update your operating system with caution
Improper operation or unforeseen external factors may cause an operating system
update fail leading to device not functioning properly. If such a situation occurs, you
need to send the unit for repair.
An unofficial operating system can cause security risks. Please install only official
updates provided by Phicomm (Shanghai) Co., Ltd., if not you will void the warranty
and a repair is chargeable.
To Next Page
Loading...
Need help?
General
Weight and Dimensions