Philips 200CW8FB/00 - Plastics Flammability; Texture;Glossing of Housing; Tilt and Swivel Base

103
HUDSON 8
103
5.8 If paint is used
z RoHS required
z WEEE require
z If new painting type need to implement, refer to UN-D 1235.
5.9 Plastic mold tooling
z Tooling to be designed to minimize cosmetic defects induced by molding process (sink, blush, weld lines,
gate marks, ejector marks, etc.). Refer to “TYV61-90007”.
z Painting to cover up cosmetic defects due to molding is strongly discouraged.
5.10 Plastics flammability
z All Plastics to be Flame Retardant UL 94-V0 or Better (if monitor weighs less than 18kg; UL94-V0 is OK).
z Base / Pedestal to be Flame Retardant UL 94-HB.
z All major plastic parts (bezel, back cover, base) need to be molded from same resin.
z ABS V0 is allowed to implement in China region for monitor body major plastic parts
(bezel, back cover, base).
z Plastic resin type selection should be referred to “TY R83-2-9002-1”s.
5.11 Texture/Glossing of housing
z The texture area and texture no should follow Philips make-up sheet.
z The exterior surfaces shall have a uniform texture.
z Philips must approve the mold texturing.
z Detail document for texture refer to “UN-D249”, “UN-D 600”.
z < = 20 gloss units
5.12 Tilt and swivel base
z Tilt angle : -5 ° +2/- 0 ° (forward)
+20 °+3/-0 ° (backward)
z Swivel angle : ______ nil
z High Adjustment : ______ nil
z Portrait Display : ______ nil
5.13 Kensington Lock
z Must meet Kensington_slot.spec “TYE-M0004”.
z MMD request metal plate in Kinsington hole.
5.14 Label
z Regulatory label / Carton label should follow Philips requirement.
z China RoHS label
z Detail document refer to Philips Engineering Reference Book.
5.15 Product dimension / Weight (Refer to SHT 191 )
z Unit dimension : mm (W) * mm(H) * mm(D)
z Packed unit dimension : mm(W) * mm(H) * mm(D) for WW
: mm(W) * mm(H) * mm(D) for China
z Net weight : Kg (Including I/F cable 300g)
z Gross weight : Kg for WW
: Kg for China