Refer to SKU
12.3 Plastic
The plastic material of the monitor must be ABS-HB (base/Front/ back). Plastic type and
color is released as follows:
Refer to MakeUp sheet/ Graphic sheet
12.4 Definition of serial number
Refer to Philips’ definition
12.5 Definition of the barcode label
Refer to Philips’ definition
12.6 Accessories
Refer to SKU
13. ECR-HANDLING
Not any change without approved ECR.
Every ECR to the golden “ samples” must be approved by PHILIPS, Even ECR for minor changes must be released
by PHILIPS.
For the ECR procedure the vendor has to send an ECR formular, necessary spec updates, datasheets and a photo
documentation. On based on documents, PHILIPS has to decide if samples are necessary till release to changes. The
vendor also has to proof be certificates and test reports, that the change has no effect on safety, EMI and TCO03.
After testing, PHILIPS has to release or reject the change request.
To Next Page
Loading...
