Philips 241P3EB/00 - 3.16 Smartpower; Brightness; Image Size; Smart Response

ʳ
ʳ
ʳʳʳʳʳ
ʳ
ʳ
ʳʳʳʳʳʳʳʳʳʳʳʳʳʳʳʳʳʳʳʳʳ˃ˁ˄
241P3LY 24” Wide FHD LCD Monitor
2010/11/30 PHILIPS 20 of 33
70 241P3 LCD
General Product Specification
C. Hot keys to trigger:
Press [Smart Image] 3 seconds or more to trigger the demo mode.
When demo mode is On, press 3 seconds or more to turn off the demo mode.
3.14.2
3.15 Smart response (over drive) [ N/A in 241P3Y]
Response time < 2 msec GtG (Typical),
3.16 SmartPower
SmartPower is DPS function
It’s possible 2 level saturation in 32 grey when Smartpower on
4 Visual characteristics
4.1 Test conditions
Unless otherwise specified, this specification is defined under the following
conditions.
(1) Input signal : As defined in 3.3, 1920x1080
non-interlaced mode (1920X1080@60Hz 148.5MHz),
signal
sources must have 75 ohm output impedance.
(2) Luminance setting : controls to be set to 300 nits with
full screen 100 % duty cycle white signal
(3) Warm up: more than 30 minutes after power on with signal supplied.
(4) Ambient light: 400 -- 600 lux.
(5) Ambient temperature: 20 ± 5 qC
4.2 Brightness
Follow Panel specification.
4.3 Image size
Actual display size 473.76 mm x 296.1 mm