241P3LY 24” Wide FHD LCD Monitor
2010/11/30 PHILIPS 25 of 33
241P3 LCD 75
General Product Specification
5.11 Plastics flammability
x
All Plastics to be Flame Retardant UL 94-HB or Better.
x Base / Pedestal to be Flame Retardant UL 94-HB.
x All major plastic parts (bezel, back cover) need to be molded from same resin.
x Plastic resin type selection should be referred to “plastic-Philips Pool monitor”.
5.12 Texture/Glossing of housing
x The texture area and texture no should follow Philips make-up sheet.
x The exterior surfaces shall have a uniform texture.
x Philips must approve the mold texturing.
x Detail document for texture refer to “UN-D249”, “UN-D 600”.
x Glossy surface > = 80 gloss units
5.13 Tilt and swivel base
x Tilt angle : -5 q +2/- 0 q (forward)
+20 q+ 0/- 3 q (backward)
x Swivel angle : -65~ +65
x High Adjustment : 130mm
x Portrait Display : 0~90°
5.14 Kensington Lock
x Must meet Kensington_slot.spec “TYE-M0004”.
x MMD request metal plate in Kinsington hole.
5.15 Label
x Regulatory label / Carton label should follow Philips requirement.
x China RoHS label.
x Detail document refer to Philips Engineering Reference Book.
To Next Page
Loading...
