Mechanical Instructions
EN 11TPM7.1E LA 4.
2011-Aug-19
Figure 4-4 Cable dressing 47"
4.2 Service Positions
For easy servicing of a TV set, the set should be put face down
on a soft flat surface, foam buffers or other specific workshop
tools. Ensure that a stable situation is created to perform
measurements and alignments. When using foam bars take
care that these always support the cabinet and never only the
display. Caution: Failure to follow these guidelines can
seriously damage the display!
Ensure that ESD safe measures are taken.
4.3 Assembly/Panel Removal
Instructions below apply to the 32PFL4606H/12, but will be
similar for other models except 47PFL4606H/xx.
4.3.1 Rear Cover
Refer to Figure 4-5
and Figure 4-6 for details.
Warning: Disconnect the mains power cord before removing
the rear cover.
1. Remove fixation screws [1] that secure the base assy, pull
out the base assy from the set. Then remove the fixation
screws [2], [3], [4] that secure the rear cover. Refer to
Figure 4-5
and Figure 4-6 for details.
2. Lift the rear cover from the TV. Make sure that wires and
flat foils are not damaged while lifting the rear cover from
the set.
19090_103_110413.eps
110413
To Next Page