Philips DigiTrak XT - Page 31

Troubleshooting
DigiTrak XT Recorder Instructions for Use 2-3
Noise artifacts on ECG signal  Ensure you have prepared the patient’s skin according
to the instructions on page 1-12.
 Ensure the electrodes are properly applied to the
patient.
 Ensure the leads are making proper contact with the
electrodes.
 Ensure patient cable (lead set) is making contact with
the electrodes.
 Replace the lead set.
No Lead Connected message  Ensure you have prepared the patient’s skin according
to the instructions on page 1-12.
 Ensure the electrodes are properly applied to the
patient.
 Ensure the leads are making proper contact with the
electrodes.
 Ensure patient cable (lead set) is connected.
 Replace the lead set.
Leads Error
 Ensure you have prepared the patient’s skin according
to the instructions on page 1-12.
 Ensure the electrodes are properly applied to the
patient.
 Ensure the leads are making proper contact with the
electrodes.
 Ensure patient cable (lead set) is connected.
 Replace the lead set.
Defective Card message  Remove and reinsert battery. Note that when you
restart the recorder, all patient and ECG information is
erased from the memory card and cannot be recovered.
 If message still appears, call for service.
Existing ECG in recorder. The
patient’s name is displayed on
the recorder screen. The
recorder does not power on.
 Download the ECG data to the Holter application.
Self test failure
 Write down the error code.
 Restart the recorder.
 Call for service.
Table 2-1 Troubleshooting (continued)
Symptom Solution