64 EN64 EN
SPECIAL PLAYBACK
Zoom
Note
• When selecting a smaller factor than the current one,
the zoom area will not be displayed.
• To exit the zoom menu, press [INFO] again at step 1.
• To cancel the zoom function, select “x1.0” using
[K / L], then press [OK].
• You cannot slide the zoomed picture on some JPEG
files.
1) During playback, press [INFO] or [ZOOM].
2) Use [{ / B] to select
, then press [OK].
DVD-Video1 1 0:00:00
3) Use [K / L] to select a desired zoom factor to zoom,
then press [OK].
1.2
1.5
2.0
DVD-Video1 1 0:00:00
Zoom menu will appear.
There are four options
(x1.0, x1.2, x1.5 and x2.0), these are displayed
excluding the current zoom rate.
Zoom area will be displayed.
4) Use [K / L / { / B] to select a desired zoom
position, then press [OK].
Zoom playback will start.
This feature allows you to assign a specific point on a disc
to be called back later.
1) During playback, press [INFO].
2) Use [{ / B] to select , then press [OK].
DVD-Video1 1 0:00:00
3) Use [K / L] to select a desired marker number.
When it reaches the desired point, press [OK].
e.g.) DVD-video
---
---
---
---
---
---
1
2
3
4
5
6
DVD-Video1 1 0:00:00
e.g.) audio CD
Audio CD1 0:00:00
---
---
---
---
---
---
1
2
3
4
5
6
The title (track) number and the time will be displayed.
4) To return to the marker later:
Use [K / L] to select the desired marker number,
then press [OK].
Marker Setting
Note
• To clear a marker, select the marker number to be
cleared, then press [CLEAR].
• All markers will be erased when you operate these
operations listed below.
– Opening the disc tray
– Turning off the power
– Record on a recordable disc
• You can mark up to 6 points.
• Marker setting is not available when you play back
the video CD with PBC function.
E7C40UD.indd 64E7C40UD.indd 64 2007/01/15 11:20:022007/01/15 11:20:02
To Next Page
Loading...
