Philips DVP721VR - Service Information for Eeprom IC Setting

1-4
SERVICE INFORMATION FOR EEPROM IC SETTING
MODEL NAME HEX BINARY
DVP721VR/00 OPT1 FC 00000000
OPT2 C3 00000000
OPT3 5B 00000000
OPT4 01 00000000
OPT5 00 00000000
DVP721VR/02 OPT1 FC 00000000
OPT2 D6 00000000
OPT3 7B 00000000
OPT4 00 00000000
OPT5 00 00000000
DVP721VR/05 OPT1 FE 00000000
OPT2 CD 00000000
OPT3 4B 00000000
OPT4 02 00000000
OPT5 00 00000000
DVP721VR/14 OPT1 BC 00000000
OPT2 DD 00000000
OPT3 5B 00000000
OPT4 04 00000000
OPT5 00 00000000
WR : OK I : EXIT MOVE : F G
EDIT : DE
1. DETECT NEW EEPROM (OPTION EDIT
SCREEN)
- Eeprom EDIT screen automatically appears if
replacing Eeprom.
- Setup option data using the cursor Up/Down key
of a remote control.
(Setup upon BOM depending on OPT1~OPT5
model)
• Since an initial remote control is set to LG for LG
model, appropriately set optiona data using the
cursor Up/Down key.
2. EEPROM WRITED COMPLETE SCREEN
- Writes data on EEPROM by using REMOCON
"OK".
- If completing the option data screen with a menu
key, Powering Off is automatically done and the
option edit screen is arranged.
3. PG ADJUST
1) Payback the SP standard tape
2) Press the “1” key on the Remote controller and
the “PLAY” key on the Front Panel the same
time, then it goes in to Tracking initial mode.
3) Repeat the above step(No.2), then it finishes
the PG adjusting automatically.
4) Stop the playback, then it goes out to PG
adjusting mode after mony the PG data.
4. EEPROM INITIAL
- SETUP is displayed in the field if pressing the
FRONT REC KEY with the remocon number
"CLEAR" key pressed in the status of powering
Off.
- AUTO SEARCH is done since the initial screen
of ACMS is serviced if powering On.
- Check basic operation (PLAY/RECORD...)
EEPROM option code No. setting EEPROM option code No. setting procedure
NAME HEX BINARY
OPT1 00 00000000
OPT2 00 00000000
OPT3 00 00000000
OPT4 00 00000000
OPT5 00 00000000
WR : OK I : EXIT MOVE : F G
EDIT : DE
MASKROM : R00
EEPROM : R01 LG CODE