7
Unscrew the deco
cover by turning it
counterclockwise, and
press the battery cover
button to remove the
battery cover. Then
the two M6 mounting
screws can be installed
to fasten the inside
escutcheon.
After completing the installation
of the strike,please check whether
the smart lock can be used
normally.
Turn clockwise to
install the deco cover,
install the battery, put
the battery cover back,
and after attach the
strike, the installation
of the smart lock is
complete.
To check whether
if the rotary knob,
mechanical keys,
and all other
components could
be used normally.
8
9
10
Insert the outside escutcheon
connection cable and the motor
cable into the corresponding
sockets on the inside escutcheon,
and then connect the front and
rear Bluetooth connecting cables,
and then align the square shaft
of the inside escutcheon with the
two rotary holes on the mortise,
then insert the square shaft into
the rotary holes, so that the inside
escutcheon is close t in the inside
door.
Put the compressed spring and
square shaft into the square shaft
hole of the inside escutcheon
accordingly.
6
7
Be sure to hide the extra mortise and the
escutcheon connecting cables in the door hole,
and also hide the extra Bluetooth connecting
cable in the inside escutcheon.
Battery cover
button
Front Bluetooth
Connecting Cable
Mortise Connecting
Cable Socket
Escutcheon Connecting
Cable Socket
Rear Bluetooth
Connecting Cable
Attention
Attention
To Next Page
Loading...
