Page 14 E
VERFLO
TM
SERVICE & TECHNICAL INFORMATION 1039055, VER. 06
Chapter 5. SYSTEM SETUP
5.1 INTRODUCTION
This section provides information regarding setup and operation of the EverFlo Oxygen Concentrator as needed
for servicing, repairing, and testing the device.
5.2 SYSTEM SETUP PROCEDURES
1.
Select a location that allows the concentrator to draw in room air without being restricted. Make
sure that the device is at least 6 to 12 inches (15 to 30 cm) away from walls, furniture, and
especially curtains that could impede adequate airflow to the device. Do not place the device
near any heat source.
2.
Plug the EverFlo Oxygen Concentrator into an electrical outlet.
3.
If you are NOT using a humidifier, connect the cannula to the EverFlo Oxygen Outlet Port, as
shown below. Proceed to step 4.
4.
If you are using a humidifier follow these steps:
a.
Open the filter door on the back of the device.
b.
Remove the humidifier connector tube from the back of the filter door and replace the filter
door.
c.
Fill the humidifier with water following the manufacturer’s instructions.
d.
Mount the filled humidifier on the top of the EverFlo device inside the velcro strap.
e.
Tighten the velcro strap around the bottle and secure it so it is held firmly in place.
f.
Connect the humidifier connector tube (that you retrieved from the filter door) to the Oxygen
Outlet Port.
g.
Connect the other end of the humidifier connector tube to the top of the humidifier with the
elbow in the tubing facing the front.
h.
Connect your cannula to the humidifier bottle according to the humidifier bottle manufacturer’s
specifications.
NOTE
Please refer to the appropriate User Manual for additional information.
To Next Page
Loading...
Need help?
General
