Philips EverFlo Q - Chapter 10. TOOLS and EQUIPMENT

Page 94 E
VERFLO
TM
SERVICE & TECHNICAL INFORMATION 1039055, VER. 06
Chapter 10. TOOLS AND EQUIPMENT
You should have the following hand tools and supplies available for troubleshooting, testing, and repairing the
EverFlo Concentrator.
Common Hand Tools
Antistatic, Electro-Static Discharge (ESD)-protected work station - minimum requirement is a grounded
mat and wrist strap
Phillips Screwdriver - medium (included in H646 Tool Kit)
Phillips screwdriver, size “00”
5/16” Hex Driver (5/16” bit included in H646 Tool Kit)
6 inch long 5/16” Hex Driver Bit Kit
9/16” Open-end wrench
9/16” Socket
Heyco Pliers
Torque Wrench 1.5 in-lbs.
Torque Wrench 8 in-lbs.
Torque Wrench 25 in-lbs.
Torque Wrench 35 in-lbs.
Torque driver 1-2 INLBS range with T6 bit.
Fuse Extractor
Concentrator Tool Kit (H647)
Diagonals (wire cutters)
Needle Nose Pliers (insulated)
Channel Locks (medium)
One Ear Clamp Pliers
Pressure Gauge
Equipment
Digital Multimeter
Calibrated Oxygen Analyzer
1/8” NPT Coupling Insert (Colder P/N MC2402 or equivalent)
Brass 1/8” NPT Male to Female Adapter (McMaster-Carr P/N 9171K610 or equivalent)
Flowmeter (Dwyer P/N VFB-67-SSV or equivalent)
Orifice 0.038” (McMaster-Carr P/N 2712T482 or equivalent)
Oxygen Interface Hardware Kit (see Section 8.2)