Page 51 E
VERFLO
TM
SERVICE & TECHNICAL INFORMATION 1039055, VER. 06
Figure 8-10: PRESSURE REGULATOR ASSEMBLY REMOVAL/INSTALLATION
4.
Connect the yellow pressure line to the Pressure Regulator Adaptor. Refer to Figure 8-9.
5.
Install the Rear Cabinet. Refer to the Rear Cabinet/Power Cord Replacement section for more
information.
6.
Install the Inlet Filter. Refer to the Inlet Filter Replacement section for more information.
7.
Install the Filter Cover. Refer to the Filter Cover Replacement section for more information.
To Next Page
Loading...
