Preparations
_C_ Speakers Connection
Front Speakers
Connect the speaker" wires to the SPEAKERS
terminals, _-ightspeaker to "g" and lefL speaker to
"L'_,coloured (marked) wire to "4-" and black
(unmarked) wire to "-- ",
Inserting batteries into the
remote control
b_sert two batter-es (Type R06 orAA) into the
remote control with the correct polarity as
ind cared by the "4-" and "--" symbols inside
the battery compartment.
• Fully insert the stripped porLion of the speaker
wire bto the termiral as shown
For optimal sound performance, use the
supplied speakers.
Do not connect more than one speaker to any
one pair of 4-/-- speaker terminals.
Do not connect speakers with an impedance
lower than the speakers supplied. Please refer to
the SPECIFICATIONS section of this manual
CAUTION!
- Remove batteries if they are exhausted
or will not be used for a long time.
- Do not use old and new or different
types of batteries in combination.
- Batteries contain chemical substances, so
they should be disposed off properly.
Optional connection
The opt onal eq pTqent and conpectin£ cords
are not supplied Refer to the operaan 8
instructions of the connected equipment ful-
details
Connecting other equipment to your
system
Use a cinch cable to connect AUX/CDR IN to
the analogue audo out termipals of an external
equipment (TVVCR, LAser Disc players DVD
player or CD Recorder)
_01te;
If you are connecting equipment with a mono
output (a single audio out terminal), connect it to
the AUX/CDR IN left terminal Alternatively, you
can use a "single to double'cinch cable (the output
sound still remain mono).
pg 001-030/C399/34-Eng 9 _ 12/24/01, 11:48 AM] 139 115 21241
To Next Page
Loading...
