ENGLISH
39
Warning Signals (orange colour)
The machine is warming
up to brew co ee and
dispense hot water and
steam.
The Brew Group is being
reset due to machine reset.
The machine is perform-
ing the rinse cycle.
Wait until the machine
stops the operation.
Re ll the co ee bean hopper
with co ee beans and restart
the brewing cycle.
The machine needs the
"INTENZA+" lter to be
replaced.
Prime the circuit.
If this page is displayed after starting the machine, this means that a descaling cycle
is needed.
Press the " " button to enter the descaling menu and refer to the relevant sec-
tion.
Press the " " button to go on using the machine.
We remind you that damages caused by failure to descale the machine are not
covered by warranty.
Warning Signals (red colour)
Close the service door.
Insert the co ee grounds
drawer.
No co ee beans in the
co ee bean hopper.
After re lling the hop-
per, the cycle can be
restarted.
Empty the co ee grounds
drawer and the liquid recov-
ery tray.
The Brew Group must
be inserted into the
machine.
Fill the water tank.
Turn o the machine. After 30 seconds, turn it on again. Try this 2 or 3 times.
If the machine does NOT start, contact an authorised service centre.
To Next Page
Loading...
