ENGLISH
9
3
Once the warm-up is complete, the machine performs a rinse cycle of
the internal circuits.
During this phase, the icon indicated in the gure will be displayed.
4
When the operations described above are complete, the icon is displa-
yed.
The machine is ready to brew beverages.
5
To brew co ee or dispense hot water or steam, and for a proper use of
the machine, carefully follow the instructions provided.
Note: If the machine is being used for the rst time or after a long period of
inactivity, follow the procedures described in the following section.
Rinse/Self-Cleaning Cycle
After the automatic priming of the circuit, the machine will automatically
rinse/clean the circuit. This cycle allows rinsing the internal co ee circuits
with fresh water. The cycle is automatically performed also in the following
conditions:
• At machine start-up (with cold boiler)
• After priming the circuit (with cold boiler)
• During the Stand-by preparation phase (if a co ee product has been
brewed)
• During the turning o phase after pressing the ON/OFF button (if a
co ee product has been brewed).
A small amount of water will be dispensed to rinse and heat all the ma-
chine components; in this phase this icon is displayed.
We strongly recommend to wait for the cycle to nish automatically.
The dispensing procedure can be stopped by pressing the "
" button.
For a perfect Espresso: Rinse the co ee circuit if using the machine
for the rst time or after a long period of inactivity.
Besides the rinse/self-cleaning cycle, we recommend you to run these
simple operations to always brew excellent espresso.
They have to be performed:
A) At rst start-up;
B) When the machine remains inactive for a long time (more than 2
weeks).
1
Place a large container under the dispensing spout.
OrangeGreen
Orange
To Next Page
Loading...
