74 EN
Set digital output
Select a suitable setting if you have connected
an audio/video device to the COAXIAL socket
on the recorder.
1 Press HOME.
2 Select [ Settings ], then press OK.
3 Select [ Audio ] > [ Digital Output ], then
press X.
4 Select an option and press OK.
[ PCM ]
Select this if the connected device cannot
decode multi-channel audio. The recorder
converts Dolby Digital and MPEG-2 multi-
channel signals to PCM (Pulse Code
Modulation).
[ All ]
Select this if the connected device
supports multi-channel audio format. The
audio output is played according to the
audio stream on the disc.
5 To exit the setup menu, press the Blue
button [ Exit ].
Set HDMI audio
See the chapter ‘Adjust Settings – Adjust HDMI
video and audio’.
Enable night mode
Night mode optimises playback of sound at low
volumes
1 Press HOME.
2 Select [ Settings ], then press OK.
3 Select [ Audio ] > [ Night Mode ], then
press X.
4 Select an option and press OK.
[ On ]
Enable night mode. High volume outputs
are softened and low volume outputs are
increased to an audible level.
[ Off ]
Disable night mode. Enjoy surround sound
with its full dynamic range.
5 To exit the setup menu, press the Blue
button [ Exit ].
hdr3800_31_eng_29522.indd 74hdr3800_31_eng_29522.indd 74 2008-07-18 11:46:18 AM2008-07-18 11:46:18 AM
To Next Page
Loading...
