What to do if Philips M1013A IntelliVue G1 Measuring Instruments show -?-, INOP tone, and blinking Setup LED?
If your Philips Gas Analyzer displays '-?-' instead of numerics, emits an INOP tone, and the Setup LED is blinking, this indicates a hardware problem. Check the connection to the monitor. Try switching the Gas Analyzer off and then on again to resolve the issue.
What to do if Philips Measuring Instruments show GM OCCLUSION error?
If your Philips Measuring Instruments display 'GM OCCLUSION' and numerics are replaced by '-?-' with an INOP tone, ensure the sample and exhaust lines aren't kinked. Check the airway adapter for water buildup, empty it, and reposition the adapter so the port faces upwards. Consider replacing the sample line, watertrap, or exhaust line.
Why Philips M1013A IntelliVue G1 show GM NOT AVAILABLE error?
If your Philips Measuring Instruments display 'GM NOT AVAILABLE' with an INOP tone, it means the Gas Analyzer is either disconnected or switched off. Ensure it is properly connected and powered on.
How to fix Philips Measuring Instruments GM ZERO FAILED error?
If your Philips Measuring Instruments display 'GM ZERO FAILED' and numerics are shown as '-?-', check the exhaust tube for any occlusions or kinking, and replace it if necessary. You can also manually start another zero calibration.
Why is Philips Measuring Instruments GM accuracy reduced?
If your Philips gas analyzer displays numerics as '-?-' and the measurement accuracy seems reduced, check that the gas inlet, watertrap, and gas outlet tubing are not occluded.
What does GM COMPONENT MALF mean on Philips M1013A IntelliVue G1 Measuring Instruments?
If your Philips Measuring Instruments display 'GM COMPONENT MALF' and numerics are shown as '-?-', it indicates a gas analyzer component is malfunctioning. Try switching the gas analyzer off and then on again.
What to do if Philips Measuring Instruments show the same value for et and in numerics?
If your Philips Measuring Instruments display the same value for both 'et' and 'in' numerics with a 'GM NO BREATH' message, check the patient connections to ensure they are correctly set up.
Why Philips M1013A IntelliVue G1 show GM WARMUP error?
If your Philips Measuring Instruments display 'GM WARMUP' and numerics are shown as '-?-', it means the gas analyzer has not yet reached its operating temperature. Therefore, the measurement accuracy may be reduced.
What does AGT MEAS MALFUNCTION mean on Philips Measuring Instruments?
If your Philips Measuring Instruments display 'AGT MEAS MALFUNCTION,' with numerics replaced by '-?-' and an INOP tone, switch the gas analyzer off and then on again.
What does GM CHECK WATERTRAP mean on Philips M1013A IntelliVue G1?
If your Philips Measuring Instruments display 'GM CHECK WATERTRAP', check that the sample line and/or watertrap is not disconnected.
Steps to verify IntelliVue G1/G5 functionality using the VISIA tool before software update.
Step-by-step guide for updating the IntelliVue G1/G5 software using the VISIA tool.
Details safety test types, precautions, and general procedures for testing.
Specific tests for protective earth resistance and equipment leakage current.
Procedures for checking and calibrating the gas analyzer's performance.
Lists INOP messages, their indications, and recommended actions to resolve them.
General| Brand | Philips |
|---|---|
| Model | M1013A IntelliVue G1 |
| Category | Measuring Instruments |
| Language | English |
To Next Page