79
6
6Repairing the Gas Analyzer
Introduction
This section contains detailed removal and replacement procedures for all field-replaceable units in the
gas analyzer.
Who Should Perform Repairs
Only qualified service personnel should open the IntellIVue G1 / G5 housing, remove and replace
components, or make adjustments. If your medical facility does not have qualified service personnel,
contact Philips’ Response Center or your local Philips representative.
WARNING • Switch off the instrument and disconnect it from the mains power supply. Take standard
electrostatic precautions. For example, a wrist strap connected to electrical ground.
• Voltages dangerous to life are present in the instrument. Do not perform any disassembly or
reassembly procedures with power applied to the instrument. Failure to adhere to this warning could
cause serious injury or death.
Tools required
• 1 hexagon socket screw key (4.0)
• 1 hexagon socket screw key (2.5)
• ESD mat and wrist strap
NOTE Your IntelliVue G1 / G5 may look slightly different than on the pictures in this chapter, depending on
the options ordered
To Next Page
Loading...
