4
Securing the Power Cord 19
Connections to the Sample Gas Exhaust 20
Returning the Gas Sample 20
Setting Up the Gas Return 20
Removing the Gas Sample 21
Installing the Top Mount 21
Mounting Instructions 22
Setup and Configuration Procedures 23
IntelliVue Serial Port Configuration 23
Altitude Configuration 23
Connect Sample Input Tubing 23
Post-Installation Checks 23
Safety Requirements Compliance and Considerations 23
Explanation of Symbols Used 24
Electrical and Safety Requirements (Customer or Philips) 24
Power Supply Requirements 24
Protective Earthing of the System 25
Equipotential Grounding 25
Combining Equipment 25
Connecting Non-Medical Devices 25
3 Software Uploads 27
Checking the Unit for Functionality 28
Uploading the Software 32
4 Testing and Maintenance 41
Introduction 41
Terminology and Definitions 41
Recommended Frequency 42
When to perform Tests 42
Testing Sequence 43
Visual Inspection 43
Before Each Use 43
After Each Service, Maintenance or Repair Event 43
Power On Test 44
Safety Tests 44
Warnings, Cautions, and Safety Precautions 44
Safety Test Procedures 45
Hints for Correct Performance of Safety Tests 47
Guideline for Performance of Safety Tests 47
Electrical Safety Testing 48
S(1): Protective Earth Resistance Test 48
S(2) Equipment Leakage Current Test - Normal Condition 49
S(3) Equipment Leakage Current Test - Single Fault Condition 50
Reference: Allowable Values for IEC 60601-1:1998 and UL 60601-1 Measurements 51
Insulation Resistance 51
To Next Page
Loading...
Need help?
General
