54
English
NEWS
It is possible to set up the tuner in such a
way that any playback is interrupted by the
news of an RDS station. However, this only
works if the RDS radio station broadcasts
the necessary signal while sending the news.
The NEWS function can be activated from
any mode except tuner mode.
Activating the NEWS function
● In any active mode (except PC link mode
and tuner mode), press RDS•NEWS on the
remote control.
➜ NEWS is shown and NEWS is displayed
briefly.
➜ The current active mode remains
uninterrupted while the set will scan the
first 5 preset radio stations and waits for
the signal in any of the RDS stations.
➜ When a news transmission is detected,
the set will switch to tuner and
NEWS
starts flashing.
Notes:
Make sure the first 5 preset radio stations
have RDS stations. If no RDS station is
detected in the first 5 presets, the set will exit
from the NEWS function,
NEWS goes off and
NO RDS NEWS is displayed.
The NEWS function works only once for
each activation.
Deactivating the NEWS function
● Press RDS•NEWS again on the remote
control or switch the set to tuner.
➜ NEWS goes off and NEWS OFF is
displayed briefly.
Tuner
To Next Page
Loading...
