Philips PM 5167 - Technical Data

8
1.2. TI :CHNICAL DATA
Gr neral instructions
- a.c. voltages are, if not quoted otherwise, stated as r.m.s. values
- only values with tolerances or limits of error apply as guaranteed data
- relative faults (in per cent or ppm) relate to the adjusted value
- 311 specifications will met af ter a warming·up period of 30 minutes
-
Fr equency
Rlnge
SE tting
A,ljustment
O fset
A,;curacy
1. time symmetrical waveforms
2. time asymmetrical waveforms
T,·mperature coefficient
L, ,ng·term drift
F equency variation
\1113veforms
SI 'le wave
SIluare wave
T
iangular wave
Si wtooth
Pltlse
O Jtputs
1. With selectable waveform
AC voltage
DC·offset
Impedance
Attenuation
Rise/fall time of square wave
* ±0.2 % of maximum range value
: 1 m Hz ... 10M Hz in ten sub·ranges of one decade
: by means of step·switch 1 m, 10m, 0.1 ... 1 M
:
continuous, by 3 turns knob and linear scale
:
-5 % ... ±5 % relative variation
: ±6 % in range 1 m
±5 % in range 10 m
±2 %* in range 0.1 to 10 k
±3 %* in range 100 k
±4 %* in range 1 M
:
±8 % in range 1 m
±7 % in range 10 m
±3 %* in range 0.1 to 10 k
±4 %* in range 100 k
: < 0.3 %/oC up to 8 MHz
: < 0.2 % in 7 hours after a warming·up period of 4 minutes
at a constant temperatu re of 25
0
C
: < 50 ppm at nominal mains voltage ±1O %
rov
~ , duty cycle 0.5
"v
:/"""\, duty cycle 0.1 up to 1 MHz
~, duty cycle 0.9 up to 1 M Hz
: f1.J , duty cycle 0.9 up to 1 M Hz
IL, duty cycle 0.1 up to 1 MHz
-
:
max. 40 V pp (open circuit)
: O ... ±10 V
-
: 50n
: Continuous> 30 dB
1 Step, 20 dB
: < 25 ns up to lOV pp
< 30 ns up to 20 V pp
.~