EN
19
Configuration
Introduction
The SLA5520 has a Configuration Wizard that guides you through the process of
configuring network profiles for your SLA5520. The Configuration Wizard is used
when you want to:
• Install the SLA5520 for the first time.
• Make later changes to a network profile setting.
This chapter describes:
• Information you will need to configure the wireless network profile for the
SLA5520
• Structure of the Configuration menu
• How to use the Configuration Wizard to change network profile settings
Network Information needed by the Configuration Wizard
The Configuration Wizard will guide you through the setup process, prompting you
to edit one or more of the following settings. Before proceeding, make sure that you
have the following information in front of you:
Note: The SLA5520 determines some settings automatically during its search for an
available wireless network. It may therefore not need to prompt you for all of
the above settings during the setup process.
Prompt Option Selected Information You Need To Know
Select Network Other (Advanced) Current Network SSID (to confirm)
Alternative Network SSID
Select wireless mode Network (Infrastructure) Is there an Access Point available
on the wireless network?
Select security type WPA, WEP, None Key Index and Encryption Key
Network settings Automatic (DHCP) Is a DHCP Server Available?
Manual (Static IP) IP Address (for SLA5520)
Subnet Mask
Gateway
Preferred DNS Server
Alternate DNS Server
To Next Page
Loading...
