EasyManua.ls Logo

Philips Sonicare ProtectiveClean 5300 - Product Care and Replacement; Cleaning Toothbrush Components

Philips Sonicare ProtectiveClean 5300
114 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
20
English
Cleaning
Toothbrush handle
1
Remove the brush head and rinse the metal shaft area
with warm water. Make sure you remove any residual
toothpaste.
Caution: Do not push on the rubber seal on the metal
shaft with sharp objects, as this may cause damage.
2
Wipe the entire surface of the handle with a damp
cloth.
Note: Do not tap the handle on the sink to remove excess
water.
Brush head
1
Rinse the brush head and bristles after each use.
2
Remove the brush head from the handle and rinse the
brush head connection with warm water at least once
a week. Rinse the travel cap as often as needed.
Charger
1
Unplug the charger before you clean it.
2
Wipe the surface of the charger with a damp cloth.
Travel case
Rinse with warm water and use a damp cloth to clean
inside of travel case.
Cleaning the Sanitizer
Warning: Do not immerse the sanitizer in water or
rinse it under the faucet.
Warning: Do not clean the sanitizer when the UV
light bulb is hot.
For optimal effectiveness, it is recommended to clean
your sanitizer weekly.
1
Unplug the sanitizer.

Table of Contents