UM EN AXL F SYS DIAG
26
PHOENIX CONTACT 8663_en_03
Table 2-4 Additional codes
Additional
code (hex)
Meaning
0000 No detailed information on the cause of error.
0010 Service parameter with invalid value.
0011 Subindex not available
0012 Object access is not a request
0013 Service code is not supported
0014 Subslot is not supported
0015 Object access type not supported on this object.
0016 Object access request index for this AccessType does not equal 0000
hex
.
0017 Object access request length for this AccessType does not equal zero.
0018 Object length for this object does not match
0019 Object is ReadOnly and cannot be overwritten.
001A Object is WriteOnly and cannot be read.
001B Write/read access to the object is not permitted.
001C Access requires Upload-Read or Download-Write.
0020 Service cannot be executed at present.
0021 Due to local control, service cannot be executed at present.
0022 Service cannot be executed in current device state (device control).
0023 Service cannot be executed at present as no object dictionary is available.
0030 Value range of a parameter out of range.
0031 Parameter value too large
0032 Parameter value too small
0040 Collision with other values
0041 Communication object cannot be mapped to the process data.
0042 Process data length exceeded
0050 Firmware download rejected: general.
0051 Firmware download rejected: incorrect update version.
0052 Firmware download rejected: incorrect firmware version for the hardware.
0053 Firmware download rejected: identical firmware block.
0080 Hardware error
0081 Application failed
00A0 Invalid segment number, e.g., upload without initiation with subindex ==FF
hex
.
00A1 Resource not available; No more resources (memory) available for download.
00A2 Incorrect CRC (checksum)
00A3 Error opening the file (if file system is available)
00A4 Error writing the file (if file system is available)
00A5 Error closing the file (if file system is available)
To Next Page
Loading...
Need help?
General
