Phoenix Contact Axioline F AXC Series User Manual

Error codes
8663_en_03 PHOENIX CONTACT 25
F 1 Hardware or firmware error Restart the device. If the problem still
occurs, please contact
Phoenix Contact.
2
3
4 Inconsistent parameters Check the parameters.
5PDI object
index
Invalid parameters Check the parameters.
6PDI object
index
Access not supported. Check the call.
8PDI object
index
Maximum number of permitted parallel PDI ser-
vices exceeded
Wait until the services have been
processed.
CUnknown
Variable_ID
Incorrect variable ID for Set_Value or
Read_Value.
Check the call.
D Internal error Restart the device. If the problem still
occurs, please contact
Phoenix Contact.
11 Device not accessible (bus error). Check the bus configuration.
12 Device cannot be reached (timeout). Check the device.
13 Device not accessible because it was removed. Check the bus configuration.
21 Invalid device
number
Invalid slot number 
(Value is 0 or larger than the maximum number
of devices)
Check the call.
22 Invalid device
number
Slot is not active. Check the call.
23 Invalid data
length
Invalid data length. Check the call.
24 Invalid num-
ber of param-
eters
Invalid number of parameters. Check the call.
31 Internal error Restart the device. If the problem still
occurs, please contact
Phoenix Contact.
32
33
Table 2-3 Error codes when calling the PDI services [...]
Code
(hex)
Code
(hex)
Additional
code
Meaning Remedy

Phoenix Contact Axioline F AXC Series Specifications

General

Brand	Phoenix Contact
Model	Axioline F AXC Series
Category	Control Unit
Language	English