CONTACTRON-DTM-IFS device drivers
104456_en_01 PHOENIX CONTACT 7-15
7.4 EMM 3- xx/500AC/xx-IFS module parameter menu
The operating behavior of the EMM 3- xx/500AC/xx-IFS module is adapted by means of the
individual parameters that can be set. In the dialog boxes illustrated below, the parameters
can be set according to the required application and transmitted to the
EMM 3- xx/500AC/xx-IFS.
7.4.1 User interface
The parameter data of the EMM 3- xx/500AC/xx-IFS module can be accessed via a menu
structure from the parameter user interface. The project data can either be loaded and
modified in XML data format from the hard disk of the service PC or adapted directly in
online mode.
Figure 7-10 Activated online connection to the EMM 3- xx/500AC/xx-IFS module
Parameters that are not edited are always preassigned the default settings on the
program side.
Parameters that are modified in online mode must be saved separately on the service PC.
An activated online connection to a EMM 3- xx/500AC/xx-IFS module is indicated by the
green background in the project tree of IFS-Conf.
http://www.RSPSupply.com/p-793-Phoenix-Contact-2986122-Memory-Block-IFS-CONFSTICK.aspx
To Next Page
Loading...
Need help?
General
