TROUBLESHOOTING
No Power
● Perhaps the most obvious question, but is it
plugged in?
● Is the AC outlet that the MAX amp is connected
to active? Test it with a lamp.
● Is the power switched on?
● Is the power LED illuminated? If not, make sure
that the unit is plugged in, turned on and the AC
outlet is live. If it is illuminated, check the “No
Sound” section below.
● Failing all of this, the most likely cause is the fuse
inside the amplier’s power supply has blown. As
users cannot service this part, please contact your
country’s distributor for assistance. You can nd
their details on www.phonic.com/where.
No Sound
● Have you turned up the level controls? If not, turn
them up slowly to see if you can hear anything.
● Is your source material turned up and active?
Ensure that the level of the mixer (or whichever
device is connected to your amplier’s inputs) is
high enough to produce a signal. The signal LED
on the front panel should give you some idea of
whether this is so.
● Check the temperature of the unit by putting a
hand nearby. If there is no heat, you’re ne. If you
can feel obvious heat emitting from the unit, it’s
possible that the thermal protection function has
kicked it. You may need to turn the unit off and
wait for it to cool down before it can function as
normal.
● Ensure your speakers to make sure they are
working correctly. If your speakers have fuses,
check if they’ve blown.
Poor sound
● Is the signal loud and distorted? If so, turn down
the level of the source signal.
● Is the clip LED ashing quickly or staying con-
stantly on? If so, try reducing the Amplier’s level
controls.
● Ensure that the input connectors are pushed
rmly into the jack. Make sure your speakers are
connected correctly.
● Try connecting a set of headphones into your
signal source to see how the signal sounds there.
If you’re getting the same result, then the problem
is your source rather than the amplier.
To Next Page
Loading...
