Phonic SUMMIT - Digital Effect Table - Modulation and Delay; Tap Delay Effect Parameters; Chorus Effect Parameters; Flanger Effect Parameters

38 SUMMIT
Tap Delay Feedback 0 to 99% Adjusts the feedback gain of input signal
Tap Button 1 ms to 5 sec Push twice to adjust the tap delay time
LPF 20 Hz to 20 kHz Adjusts the low pass lter frequency of the signal
HPF 20 Hz to 20 kHz Adjust the high pass lter frequency of the signal
Chorus L.F.O. 0.1 to 20 Hz Low frequency oscillation
Phase 0 to 180∘ Modulation phase adjustment
Mode Type Sine / Triangle Determines the modulation waveform
Depth 0 to 100% Chorus depth/density
Pre Delay 0 ms to 1 sec Early delay before the chorus effect begins
LPF 20 Hz to 20 kHz Low pass lter cut-off frequency
Flanger L.F.O. 0.1 to 20 Hz Low frequency oscillation
Phase 0 to 180∘ Modulation phase adjustment
Wave Sine / Triangle Determines the modulation waveform
Depth 0 to 100% Modulation depth
Pre Delay 0 ms to 1 sec Early delay before the anger effect begins
LPF 20 Hz to 20 kHz Determines the anger low pass lter cut-off frequency
FB 0 to 99% Determines the feedback gain of the anger effect
Phaser L.F.O. 0.1 to 20 Hz Low frequency oscillation
Wave Sine / Triangle Determines the modulation waveform
Depth 0 to 100% Adjusts the depth of the Phaser effect
Frequency 20 Hz to 20 kHz Determines the modulation frequency of the Phaser
Stage Number 2, 4, 6, 8 Determines the number of all-pass lters, or stages, in
the Phaser effect
Vibrato L.F.O. 0.1 to 20 Hz Low frequency oscillation
Wave Sine / Triangle Modulation waveform of the Vibrato effect
Depth 0 to 100% Determines the depth of the Vibrato effect
Frequency 20 Hz to 20 kHz Determines the modulation frequency of the Vibrato ef-
fect
Tremolo L.F.O. 0.1 to 20 Hz Low frequency oscillation
Wave Sine / Triangle Determines the modulation waveform
Depth 0 to 100% Adjusts the depth of the Tremolo Effect
Auto Pan L.F.O. 0.1 to 20 Hz Low frequency oscillation
Mode Sine / Triangle Determines the modulation waveform
Depth 0 to 100% Adjusts the depth of the Auto Pan effect
Way
LR / L  R / R  L
Determines the direction of the panning effect
Note: Reverb Effects are found on EFFECT 1 only.