Phonic SUMMIT - Digital Effect Table - Reverb and Echo; Reverb Effect Parameters; Echo Effect Parameters

37SUMMIT
DIGITAL EFFECT TABLE
Effect Parameter Range Description
Reverb Room (Large Room,
Medium Room, Small Room,
Live Room, Bright Room,
Wood Room, Heavy Room,
Opera Room)
H.P.F. 20 Hz to 20 kHz Adjusts the high pass lter cut off frequency
L.P.F. 20 Hz to 20 kHz Adjusts the low pass lter cut off frequency
Rev Time 50 ms to 10 sec Adjusts the reverb time of the effect
Pre Delay 0 to 100 ms Adds a delay prior to the effect being applied
Early Out 0 to 100% Adds a delay between early reections and the reverb
Hi Ratio 0 to 100% High frequency reverb ratio
Density 0 to 100% Reverb density
Level 0 to 100% Determines the level of reverb applied to the signal
Gate Threshold -70 to 0 dB Adjusts the gate threshold
Gate Hold Time 1 ms to 8 sec Adjusts the time the gate will hold after the threshold is
passed
Reverb Hall (Large Hall,
Medium Hall, Small Hall,
Concert Hall, Dark Hall,
Wonder Hall, Jazz Hall, Vocal
Hall)
H.P.F. 20 Hz to 20 kHz Adjusts the high pass lter cut off frequency
L.P.F. 20 Hz to 20 kHz Adjusts the low pass lter cut off frequency
Rev Time 50 ms to 10 sec Adjusts the reverb time of the effect
Pre Delay 0 to 100 ms Adds a delay prior to the effect being applied
Early Out 0 to 100% Adds a delay between early reections and the reverb
Hi Ratio 0 to 100% High frequency reverb ratio
Density 0 to 100% Reverb density
Level 0 to 100% Determines the level of reverb applied to the signal
Gate Threshold -70 to 0 dB Adjusts the gate threshold
Gate Hold Time 1 ms to 8 sec Adjusts the time the gate will hold after the threshold is
passed
Reverb Plate (Large Plate,
Medium Plate, Small Plate,
Flat Plate, Light Plate, Thin
Plate, Perc Plate, Industrial
Plate)
H.P.F. 20 Hz to 20 kHz Adjusts the high pass lter cut off frequency
L.P.F. 20 Hz to 20 kHz Adjusts the low pass lter cut off frequency
Rev Time 50 ms to 10 sec Adjusts the reverb time of the effect
Pre Delay 0 to 100 ms Adds a delay prior to the effect being applied
Early Out 0 to 100% Adds a delay between early reections and the reverb
Hi Ratio 0 to 100% High frequency reverb ratio
Density 0 to 100% Reverb density
Level 0 to 100% Determines the level of reverb applied to the signal
Gate Threshold -70 to 0 dB Adjusts the gate threshold
Gate Hold Time 1 ms to 8 sec Adjusts the time the gate will hold after the threshold is
passed
Echo Time 1 0 to 640 ms Adjusts the delay time of input 1
Time 2 0 to 640 ms Adjusts the delay time of input 2
Feedback 1 0 to 99% Feedback gain of input 1
Feedback 2 0 to 99% Feedback gain of input 2
FB HPF 20 Hz to 20 kHz Feedback High Pass Filter
FB LPF 20 Hz to 20 kHz Feedback Low Pass Filter