• Insert the included funnel into the tank (you can place the filter in the
funnel) and pour the liquid hopper into the jar at the four corners of the
tank.
• Use the soft scraper to gently scrape off the remaining resin. If there is
any residue adsorbed on the bottom of the tank, it can be easily removed
by pouring it into alcohol for 10 minutes.
• Sealed cans with old resin. Set the cool place, use it again next time.
Precautions
o If the resin is found to be insufficient in the middle of printing, please
replenish the resin immediately. A good feeding timing is to pour the resin
between the printing layers, the stage is raised, and the LCD is not lit.
o When cleaning the bottom of the tank, use a napkin that does not drop the
chips.
o If the resin is sprayed onto the machine, wipe it off immediately.
o If the resin is left in the tank, remember to stir evenly before using it next
time.
o If it is necessary to remove the resin tank, it is strongly suggested to perform
the removal after shutting down.
To Next Page
Loading...
