N-470 Linear Actuator MP125E Version: 1.2.0 21
Installing an N-470 with mounting thread
1. Screw the mounting nut of the N-470 as far as necessary in the direction of the base
body of the N-470.
2. Optional: Apply a small amount of lubricant to the contact surface of the moving part of
the mechanical mounting.
3. Screw the N-470 as far as necessary into the M10×1 through-hole of the mechanical
mounting.
4. Align the base body of the N-470 with the mechanical mounting.
5. Fix the N-470 in the mechanical mounting:
a) Hold the base body and screw the mounting nut of the N-470 in the direction of the
mechanical mounting.
b) Hand-tighten the mounting nut with the hook wrench.
6. Check that the linear actuator is fixed firmly in the mounting.
7. Optional: Turn the screw head of the linear actuator's fine-threaded screw into the
desired position by hand to avoid longer travel to this position.
Installing an N-470 with clamping shank
1. Optional: Apply a small amount of lubricant to the contact surface of the moving part of
the mechanical mounting.
2. Remove the mounting nut from the clamping shank of the N-470.
3. Position the N-470 in the mechanical mounting of your application.
4. Manually screw the mounting nut of the N-470 a few turns into the thread of the
clamping shank.
5. Align the base body with the mechanical mounting.
6. Clamp the N-470 firmly in the mounting:
− Hold the base body and hand-tighten the mounting nut of the N-470 with the hook
wrench.
7. Check that the linear actuator is fixed firmly in the mounting.
8. Optional: Turn the screw head of the linear actuator's fine-threaded screw into the
desired position by hand to avoid longer travel to this position.
To Next Page
Loading...
