Ensure the hinges are free to move and have no excessive clearance or deformation.
Cylinder and jack
Check that the jack stem is properly extended and that it is free of scratches, dents or
deformations. In the event of faults, please contact the manufacturer or an authorised
workshop.
Hydraulic system piping and valves
Ensure the pipes, joints, and fittings on all components are leak free. In particular,
check the flexible pipes are not damaged. In the event of faults, please contact the
manufacturer or an authorised workshop.
Lubrication and greasing
All system moving components must be lubricated with oil or grease every 25 working
hours and again every 30 - 40 days, according to the operating environment (moist,
fine sand, dust, or polluting or corrosive substances, etc.). Lubricated pins and hinges
with suitable grease.
Hydraulic oil
Check the oil level and, if necessary, top it up. If the load bed fully tilted, take into
account the amount of oil inside the cylinder.
•
Use only recommended hydraulic fluid.
•
Do not mix the oil with another type.
•
Replace the fluid completely every 4 years and clean the reservoir.
•
Replace the oil completely every 150/200-work hours.
Recommended products
AGIP ARNICA 46
115
To Next Page
Loading...
