15_04
The vehicle load must not exceed the maximum tolerances set for in the Road Reg-
ulations or the allowable tolerances specified by the manufacturer. For information on
load tolerances (overall and per axle) refer to the Technical Specifications section.
The value for the overall mass is given in the vehicle registration papers.
Remember that loading the vehicle in excess of the values given in the Traffic Regu-
lations and on the manufacturer's plate, even for short trips, runs the serious risk of
damage to the vehicle due to the excessive stress exerted on the vehicle's parts and
on the tipping components, and may also result in sanctions under Traffic Regulations
regarding overloading.
Scheduled Maintenance
CAUTION
WARNING
BEFORE CARRYING OUT ANY OPERATION WITH THE LOAD BED TILTED AND
UNLOADED, IT WILL BE NECESSARY TO FIT THE SPECIAL PROP HINGED ON-
TO THE CHASSIS AND INSERTED INTO THE ATTACHMENT UNDERNEATH THE
LOAD BED. SUCH A DEVICE MUST BE REPLACED ONLY AFTER THE OPERA-
TION HAS BEEN COMPLETED AND BEFORE THE LOAD BED IS LOWERED.
Counter-chassis attachments and connections to the chassis
Ensure all bolts securing the counter-chassis to the chassis are tightened and, if nec-
essary, tighten any loosen bolt.
Hinges
114
To Next Page
Loading...
