Before performing this operation, check the reverse lever position. If you cannot start
the engine even with the procedure described above, contact an Authorised PIAG-
GIO Service Centre.
CAUTION
NEVER STRESS THE ENGINE AT LOW TEMPERATURES IN ORDER TO AVOID
POSSIBLE DAMAGE. WHEN DRIVING DOWNHILL, DO NOT EXCEED TOP
SPEED OR THE ENGINE COULD BE DAMAGED BY PROLONGED OVERREV-
VING.
CAUTION
•
AFTER A LONG JOURNEY ALLOW THE ENGINE TO RUN AT IDLE
SPEED FOR A FEW SECONDS BEFORE SWITCHING IT OFF.
03_10
Gear position (03_10, 03_11, 03_12)
To reverse the vehicle, proceed as follows:
1. Stop the vehicle completely and turn the gear selector to neutral (position «N» on
the gear indicator «B») while the engine is idling;
2. For gasoline versions, lift the reverse gear control lever from position «A» to position
«B».
3. Diesel versions are not equipped with a reverse gear control lever.
4. Use the gear control lever to engage gears; («1stgear» for the gasoline version,
«R» for the handlebar version), and gently release the clutch pedal while gradually
pressing the accelerator pedal.
22
To Next Page
Loading...
