forth in directive 89/392/EEC and amendments, in the 91/368/EEC, 93/44/EEC ap-
plicable standards and CUNA standards NC 173-01, 173-02, 173-03,173-04 and
173-05
.
Reference:
•
drawings of the overall vehicle, the chassis, the tilting system components,
the control and safety devices.
•
Illustrations of the fitted vehicle.
Equipment Layout
The tilting system consists of:
•
-a base chassis (cabin with centre member);
•
-a counter-chassis built with a pressed-sheet structure bolted onto the base
chassis;
•
-body resting on a pressed-sheet loading platform and supported by cross-
beams and outline section bars; the front headboard and lateral boards are
fixed; the tailgate can be tilted and removed; the tailgate, which is equipped
with a mechanical closure system, can be lifted upward or downward.
The tailgate locking-release mechanism
is activated by moving a control lever.
In the body centre there are hinged bolt fittings connected to the end of the
pushing triangle (jack), fixed onto the body by means of an arc-welded press-
ed sheet structure.
•
-two-position lifting jack with special fittings welded onto the base chassis
and fastened onto the abovementioned hinge with an appropriate bolt fitted
on the upper part
•
.
124
To Next Page
Loading...
