There are warning plates with writings or symbols referring to the above mentioned
requirements.
Risks associated to falling or flying objects
During loading, unloading, or transport, there is a risk of objects falling off the load
bed. Such risk may be avoided solely by taking adequate precautions against such
contingencies.
Risks associated to falling or flying objects.
The precautions to be adopted are given in the instructions and concern the following:
•
Park the vehicle sufficiently far from any workplace or damaging objects.
•
Forbidding anyone from approaching the vehicle during unloading.
•
Forbidding anyone from approaching the open tailgate during unloading and
taking any action to facilitate the fall of the material.
•
Forbidding loading the vehicle above the gates' height.
•
Special requirements apply to the transport of lightweight materials. There
are warning plates with writings or symbols referring to the above mentioned
requirements.
Risks due to sharp edged surfaces and angles.
Some components and accessories may pose the risk of injury by accidental collision.
Violent collision with metal vehicle parts or accessories, even if these do not have
sharp-edged angles or cutting sections, may cause bruises or injuries.
Precautions for avoiding the risks of injury by sharp-edged surfaces or angles.
Safety measures to take into account when operating near exposed vehicle parts or
equipment components.
•
wear personal protection equipment, particularly during side board removal
or when carrying out maintenance operations.
131
To Next Page
Loading...
