FRONT WHEEL BRAKE DRUM LOCKING
When refitting the drum brake on the front wheel
axle, do not reuse the previously removed cham-
fered nut, but replace it with a new one; the locking
must be carried out chamfering carefully, as in the
figure, the collar in the existing groove on the
wheel-holder shaft, then fit the cover after filling it
with specific grease.
For the chamfering operation appropriate pliers
must be used.
Specific tooling
19.1.20047 Pliers for chamfering nuts
Recommended products
AGIP GREASE PV 2 Multipurpose grease
NLGI 2 specifications; ISO-LXBIB2
KEY:
*= chamfer.
Verifiche e regolazioni
FRONT SUSPENSION UNIT OVERHAUL - APE TM - APE P703 - APE P703V
Suspensions APE TM Benzina
SS - 118
To Next Page
Loading...
