INTERNAL BUSHING, ROLLER GEARING ON
WHEEL AXLE - WHEEL AXLE ON THE REAR
HUB - FITTING
Heat the oil-coated bushing (8) at approx. 100°.
Afterwards, with a section of tube (9), ID 36 mm,
fit the bushing in its seat. Once this operation is
completed, fit the entire rear wheel axle in the hub,
tap with a wood or plastic mallet if required.
WHEEL HUB - BRAKE DRUM - FLEXIBLE JOINT - FITTING
There are no special instructions to fit these components; it is sufficient to operate in reverse order of
disassembly, carefully following the locking torques in the table "Tightening torques", always remem-
bering to fill the dust guard lid with the required grease.
Recommended products
AGIP GREASE PV 2 Multipurpose grease
NLGI 2 specifications; ISO-LXBIB2
Suspensions APE TM Benzina
SS - 132
To Next Page
Loading...
