CHANGE CONTROL SUPPORT
VEHICLES VERSION WITH STEERING WHEEL
Rotate the crankshaft and bring the gears to such
a position to allow the stem (2) and the bushing (1)
to reach their maximum range, bring the two con-
trol levers to neutral position, fit a new gasket on
the transmission support joining surface, engage
the shoe of the upper lever on the groove of the
stanchion of the y and [4]3 speed and the slider of
the lower lever on the groove of the control bush-
ing ^ and [2]8 speed then lock the gear change
support with the two bolts and their washers.
Once the locking is done, check the regular oper-
ation of the transmission.
CHANGE CONTROL SUPPORT
VEHICLES VERSION WITH HANDLEBAR
The assembly of units such as the stator, flywheel, cylinder-piston unit, cylinder head, silencer, etc.,
requires no special precautions; it is sufficient to operate in reverse order of disassembly.
WARNING
FOR THE LOCKING OF NUTS, BOLTS AND SCREWS, SEE THE TABLE "TIGHTENING TORQUE".
APE TM Benzina Differential
DI - 95
To Next Page
Loading...
Need help?
General
