PIAGGIO Beverly 300ie User Manual

01_17
CORRECT PROGRAMMING CHECK PHASE
Insert the «MASTER» key «A» disabling the transponder «C» (i.e., by tilting the key
cap by 90°), and turn the key to «ON». Perform the engine starter operation. Ensure
that the engine does not start. Insert the programmed key «B» and repeat the starter
operation. Check that engine starts.
WARNING
SHOULD YOU START THE ENGINE WITH THE MASTER KEY (WITH TRANS-
PONDER OFF) OR IN THE EVENT OF WRONG OPERATION DURING PROGRAM-
MING, REPEAT THE PROCEDURE FROM THE BEGINNING.
01_18
Accessing the fuel tank (01_18)
Raise the lock protection tab on the fuel tank cap. Insert the key and turn anticlockwise
to remove the cap.
20
1 Vehicle

PIAGGIO Beverly 300ie Specifications

General

Engine Type	Single-cylinder, 4-stroke
Displacement	278 cc
Cooling System	Liquid-cooled
Fuel System	Electronic fuel injection
Front Suspension	Hydraulic telescopic fork
Rear Suspension	Dual hydraulic shock absorbers
Rear Brake	240 mm disc
ABS	Yes
Seat Height	790 mm
Fuel Capacity	12 liters
Width	780 mm
Max Torque	22.5 Nm @ 5, 750 rpm
Transmission	CVT
Top Speed	125 km/h