PIAGGIO Beverly 300ie User Manual

Quantity: 1 Right - 1 Left
Power: 12V - 10W
License plate light bulb Type: All glass W5W
Quantity: 1
Power: 12V - 5W
Helmet compartment light bulb Type: Cylindrical C5W
Quantity: 1
Power: 12V - 5W
Instrument panel lighting bulb Type: LED
Quantity: 4
Power: -
03_36
Front light group (03_36, 03_37, 03_38, 03_39)
To remove the front headlight assembly, proceed as follows:
- Unscrew the two screws «A» and remove the pressure covering
- Unscrew the two upper screws «E» fastening the headlight assembly
- Working on both sides of the vehicle, unscrew the lower fixing screws «C» and re-
move the headlight. Remove the rubber protection.
This gives access to the bulbs.
To replace the low-beam light act on the lamp holder«D». To replace the high-beam
light act on the lamp holder«E» unhooking the relevant pin.
To reassemble, repeat the operation but in reverse order.
60
3 Maintenance

PIAGGIO Beverly 300ie Specifications

General

Engine Type	Single-cylinder, 4-stroke
Displacement	278 cc
Cooling System	Liquid-cooled
Fuel System	Electronic fuel injection
Front Suspension	Hydraulic telescopic fork
Rear Suspension	Dual hydraulic shock absorbers
Rear Brake	240 mm disc
ABS	Yes
Seat Height	790 mm
Fuel Capacity	12 liters
Width	780 mm
Max Torque	22.5 Nm @ 5, 750 rpm
Transmission	CVT
Top Speed	125 km/h