Name: pico Technology PicoScope 2000 Series
Brand: pico Technology
Rating: 5 (1 reviews)

To Next Page

To Previous Page

Programming the 2000 Series Oscilloscopes

PicoScope 2000 Series Programmer's Guide

2.7 Oversampling

When the oscilloscope is operating at sampling rates less than the maximum, it is possible to

oversample. Oversampling is taking more than one measurement during a time interval and

returning an average. If the signal contains a small amount of noise, this technique can

increase the effective vertical resolution of the oscilloscope by the amount given by the

equation below:

Increase in resolution (bits) = (log oversample) / (log 4)

Applicability

Available in block mode only.

Other manuals for pico Technology PicoScope 2000 Series

Questions and Answers:

Need help?

Do you have a question about the pico Technology PicoScope 2000 Series and is the answer not in the manual?

General