GENERAL
2-14 / Husky 3 Foam System
© 2022 Pierce Manufacturing Inc. All Rights Reserved.
Figure 2-18: Control Head Display Modes
1350, 1332, 1330
Display setting will automatically reset to default setting (“0.5”) by cycling the batteries ON and OFF. Powering up of
the batteries will flash program revision level and then go to default injection % setting.
This is the default setting and
will come up anytime system is
turned “ON”
This is will come up when the
system is in “FILL” mode
This is will come up when the
system is at maximum capacity
due to flow rates or high
pressure
To Next Page
Loading...