Install myPNOZ
Getting started Modular safety relay,myPNOZ
1005615-EN-02
| 18
8 Install myPNOZ
The modules are supplied pre-connected. All that’s needed is to install the myPNOZ on the
mounting rail.
Prerequisites
} The control cabinet must be at least protection type IP54.
Procedure
} Open the locking slides on the back of the modules
} Place the modules on the mounting rail and attach them to the mounting rail using the
locking slides.
} Install fixing element
When installed vertically or in environments exposed to heavy vibration, the myPNOZ
should be secured using a fixing element (e.g. retaining bracket or end angle).
To Next Page
Loading...
