Need help?Do you have a question about the Pilz PNOZ ms2p HTL and is the answer not in the manual?
Specifies the validity period of the documentation for the PNOZ ms2p HTL product.
Provides guidance on how to use the manual for installation and commissioning of the product.
Explains the various hazard and information symbols used throughout the manual.
Defines the scope of the PNOZ ms2p HTL expansion module within the PNOZmulti system.
Lists the key features and capabilities of the PNOZ ms2p HTL speed monitor.
Illustrates the front view of the PNOZ ms2p HTL and identifies its connectors and LEDs.
Describes the intended application of the expansion module for monitoring standstill, speed, and rotation.
Outlines the system requirements for using the PNOZ ms2p HTL with PNOZmulti base units.
Details safety assessment, qualified personnel, warranty, and liability guidelines.
Provides essential safety precautions for operating and maintaining the unit.
Explains the built-in redundancy and self-monitoring for safety criteria.
Describes how the speed monitor independently monitors axes for standstill, speed, and direction.
Presents a block diagram showing the module's connections and interfaces.
Details the requirements for using proximity switches and incremental encoders.
Covers adapters for encoders and combining switches with encoders on a single axis.
Provides guidelines for installing the control system in a control cabinet.
Shows the physical dimensions of the PNOZ ms2p HTL module.
Explains how to connect the base unit and expansion modules.
Covers general wiring practices and considerations for commissioning.
Details the pin assignment for the 8-pin RJ45 connector.
Explains how to connect proximity switches to the module's terminals.
Describes how to connect incremental encoders directly or via an adapter.
Illustrates wiring for proximity switches and encoders on various axes.
Shows wiring for combined proximity switch and encoder on a single axis.
Provides a connection example for two proximity switches and one encoder.
Details the wiring for connecting four proximity switches.
Shows a specific wiring example for an encoder and switch on one axis.
Explains the function of each LED indicator on the PNOZ ms2p HTL.
Details the meaning of various signal statuses and their corresponding outputs.
Describes potential faults, malfunctions, and error signaling.
Covers electrical data, voltage tolerances, and input signal levels.
Details ambient temperature, storage, EMC, vibration, and mechanical dimensions.
Provides safety characteristic data such as PL and SIL values.
Lists the product type, features, and order number for the PNOZ ms2p HTL.
Details available accessories like terminators, jumpers, and connection terminals.
Illustrates a configuration for safe standstill monitoring.
Shows a configuration for safe monitoring with a reduced speed operating mode.
Lists contact information for technical support worldwide.
Highlights Pilz's commitment to environmentally friendly products and quality standards.
To Next Page
General
