Need help?Do you have a question about the Pilz PNOZ s2 and is the answer not in the manual?
General| Operating Voltage | 24 V DC |
|---|---|
| Width | 22.5 mm |
| Terminal Type | Screw terminals |
| Rated Operational Current Ie | 6 A |
| Response Time | 20 ms |
| Auxiliary Contacts | 1 |
| Stop Category | 0 |
| Standards | IEC 60204-1 |
| Safety Level | SILCL 3, PL e |
Defines the purpose and applications for the safety relay.
Outlines the safety regulations applicable to the device.
Details the requirements for a safety assessment before device usage.
Specifies requirements for personnel assembly, installation, and operation.
Highlights critical safety notes and conditions for safe operation.
Describes the safety-related features of the safety relay.
Details single-channel operation mode and its fault detection.
Explains the automatic start function for unit activation.
Describes the manual start function for unit activation.
Details the monitored start function with a falling edge trigger.
Details the monitored start function with a rising edge trigger.
Illustrates the timing sequences for different operating modes.
Procedure for installing the base unit without expansion modules.
Instructions for connecting base and expansion modules.
Guidelines for installing the safety relay within a control cabinet.
Describes how to set the operating mode via the rotary switch.
Step-by-step instructions for setting the desired operating mode.
Illustrates an application example for an emergency stop function.
Shows a single-channel configuration for an application example.
Demonstrates a monitored start configuration in an application.
Shows falling edge monitoring with feedback loop in an application.
Explains the meaning of the status LEDs on the unit.
Describes the error LEDs and their diagnostic meanings.
Details malfunctions related to contact behavior, like welding.
Provides technical data for the safety and auxiliary relay outputs.
Specifies conductor cross-section for screw terminals.
Specifies conductor cross-section for spring-loaded terminals.
Presents safety characteristic data for instantaneous safety contacts.
Illustrates service life graphs for relay outputs under various conditions.
To Next Page
