Need help?Do you have a question about the Pilz PNOZ s4.1 and is the answer not in the manual?
General| Type | Safety relay |
|---|---|
| Supply voltage | 24 V DC |
| Width | 45 mm |
| Depth | 121 mm |
| Terminal type | Screw terminals |
| Response Time | 20 ms |
| Standards | EN 60204-1, EN 60947-5-1 |
| Performance Level (PL) | PL e (EN ISO 13849-1) |
| Category | Category 4 |
| Safety Integrity Level (SIL) | SIL 3 (EN 62061) |
Describes the intended use of the safety relay and requirements for qualified personnel.
Provides essential safety data like PL, SIL, PFH, and PFD for compliance with standards.
Presents the block diagram and terminal configuration for different unit types.
Shows the block diagram and terminal layout for units operating with 24 V DC supply.
Shows the block diagram and terminal layout for units with 48-240 VAC/DC supply.
Details various operating modes like single-channel, dual-channel, automatic, and monitored start.
Provides instructions for installing the base unit and within a control cabinet.
Details cable length calculation and measures to prevent EMC interferences.
Explains how to set the operating mode using the rotary switch and its locking mechanism.
Illustrates wiring for supply voltage and input circuits for E-STOP and safety gates.
Demonstrates typical applications for emergency stop and monitored start functions.
Explains the meaning of LED indicators for normal status and error conditions.
Details diagnostics and remedies for specific error conditions like FAULT, POWER, IN1, IN2.
Lists key electrical data including voltage, current, and input characteristics.
Explains the interpretation of SIL/PL values and their calculation with software tools.
Presents and explains graphs indicating relay output service life based on load and cycles.
Details reductions in voltage and temperature ratings at higher operating altitudes.
Lists product order numbers and provides information on EC Declaration of Conformity.
To Next Page
