P2HZ X1
Operating Manual P2HZ X1
20124-EN-09
| 6
INFORMATION
This gives advice on applications and provides information on special fea-
tures.
Safety
Intended use
The two-hand control relay P2HZ X1 meets the requirements of EN ISO 13851 Type IIIC
and EN 60204-1.
It forces an operator to keep his hands out of the hazardous area during the dangerous
movement.
The device is suitable as a block for simultaneity, for example for mounting in press control-
lers, woodworking machinery or machine tools.
Note the respective valid regulations for these machines.
Improper use
The following is deemed improper use in particular:
} Any component, technical or electrical modification to the product,
} Use of the product outside the areas described in this operating manual,
} Use of the product outside the technical details (see chapter entitled Technical
Details [ 20]).
NOTICE
EMC-compliant electrical installation
The product is designed for use in an industrial environment. The product
may cause interference if installed in other environments. If installed in other
environments, measures should be taken to comply with the applicable
standards and directives for the respective installation site with regard to in-
terference.
To Next Page
Loading...
Need help?
General
