Need help?Do you have a question about the Pilz PSEN cs4.1n and is the answer not in the manual?
Details the safety functions and compliance with standards for the safety switch.
Specifies requirements for competent persons for installation and operation.
Details pin assignments, wire colors, and connector type for wiring.
Shows a single connection diagram for the safety switch and evaluation device.
Explains the automatic teaching process for the first actuator.
Details the steps for learning new actuators (up to 8).
Provides general installation guidelines and precautions.
Procedure for mounting the safety switch using M4 screws.
Procedure for mounting actuators PSEN cs2.1 and cs4.1.
Steps to install actuator PSEN cs2.1 using M5 screws.
Installation instructions for the low profile actuator.
Steps for attaching the low profile glue actuator.
To Next Page
General
